Tacoma 4.25 Inch Rear Bump Stops For 95-16 Tacoma DuroBumps

1st Gen Tacoma rear bump stops eliminate the shell shock effect we're all familiar with when hitting OEM bump stops. Our duel durometer bump stops easily absorb hard impacts and helps keep the vehicle stable at higher speeds in rough conditions.

The 4.25 inch rear bump stop is intended for trucks with a rear lift of 2 inch and extended shocks of up to 1 inch. These bump stops have been designed to stop wheel up travel under articulation prior to extended shocks bottoming out.

• Dual Durometer Rubber in DuroBumps allows for a smooth initial contact, with a progressively firmer compression rate to provide the ultimate bump stop.
• Small, compact, application-specific bump stops.
• DuroBumps is the only application-specific bump stop manufacturer.
• We do not manufacture a universal-fit bump stops.
• No loss of up travel. With DuroBumps being made with Dual Durometer Rubber the bump stops compress in a smooth predictable fashion.
• Thick 1/8 inch powder-coated steel base plate provides strong support for the DuroBumps and ensures solid mounting.
• Some light modifications will be required (i.e. cutting and drilling to fit your specific application).
• DuroBumps are made from the highest quality raw materials.
• All mounting hardware JIS 10.9 corrosion-resistant, metric hardware.

Note: The included standard 1/8 inch steel mounting plate may also be utilized to adapt to existing U-bolt flip kits. Some light modifications will be required (i.e. cutting and drilling to fit your specific application).

What's Included

• 1st Gen Toyota Tacoma 4.25 inch Rear DuroBumps (x2)
• JIS 10.9 metric corrosion-resistant bolts (x4)
• Single-use blue thread locker
• U-Bolt Flip Kit w/ OEM 9/16 x 3.25 x 7.75 inch Black U-Bolts
• Standard powdered-coated 1/8 inch steel plate for OEM square U-bolts.
• All mounting hardware
• Install instructions

U-Bolt Flip Kits
You need to measure your existing rear suspension from the bottom of the axle tube to the top of the leaf pack. Add 2 inch to your measurement and that will give you the length of U-Bolt you need. For example, the distance from the bottom of the axle tube to the top of the leaf pack measure 5.5 inch.

Then you add the 2 inch required for the U-Bolt flip plate and mounting hardware. This equals 7.5 inch in which case you would choose the 7.75 inch U-Bolt Flip Kit.

Please note all U-Bolts have 3 inch of thread.

DuroBumps are not a replacement for air or hydro bump stops. DuroBumps are for trail off-roaders, rock crawlers, and overlanders. At a minimum, DuroBumps require proper suspension setup and roll cage to safely and responsibly drive at high speeds off-road.

Our products are not recommended for high-speed pre-runner applications nor towing. DuroBumps are the industry-leading premium bump stops available on the market and we're sure you will agree!

Installation Note: For off-road use only. By installing these aftermarket bump stops on your vehicle you assume all risk and liability. Seller will not be held liable for any damages or loss associated with the installation or use of this product for any reason.